Physics, 19.01.2021 20:30 timothytomas2046

Focus question: Does Newton's 1st law of motion apply to the importance of wearing a seat belt? Choose the answer choice that provides the best claim to the focus question.

Yes.

No.

No, Newton's 1st law of motion does not apply to the importance of wearing a seat belt.

Yes, Newton's 1st law of motion applies to the importance of wearing a seat belt

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 19:30

A33.1 g copper object is launched from a 1.5 m 30° steel incline positioned on the floor by being pulled up a string attached to a 50.0 g mass suspended vertically over a pulley. the object is projected towards a glass table where it lands when it is at the point along its trajectory with the lowest speed. it comes to a halt when it clears the opposite edge of the table. it then falls and lands on 9 physics texts each 5 cm thick that are stacked on the floor on the opposite side of the table. assume that the table does not have a ledge and the rectangular object experiences 0.05 n of air resistance as it falls towards the books. how far and how long did the object travel and how fast does it hit the books. assume that at the moment the copper object leaves the incline, the massless string and ideal pulley break off

Answers: 2

Answer

Physics, 22.06.2019 21:00

Acentrifuge in a medical laboratory rotates at an angular speed of 3,700 rev/min. when switched off, it rotates through 54.0 revolutions before coming to rest. find the constant angular acceleration (in rad/s2) of the centrifuge. your response is within 10% of the correct value. this may be due to roundoff error, or you could have a mistake in your calculation. carry out all intermediate results to at least four-digit accuracy to minimize roundoff error. rad/s2

Answers: 1

Answer

Physics, 23.06.2019 03:20

If you divide a speed in miles per minute by 60, you get the same speed expressed in miles

Answers: 2

Answer

Physics, 23.06.2019 10:10

Now that we have a feel for the state of the circuit in its steady state, let us obtain the expression for the current in the circuit as a function of time. note that we can use the loop rule (going around counterclockwise): e−vr−vl=0. note as well that vr=ir and vl=ldidt. using these equations, we can get, after some rearranging of the variables and making the subsitution x=er−i, dxx=−rldt. integrating both sides of this equation yields x=x0e−rt/l. use this last expression to obtain an expression for i(t). remember that x=er−i and that i0=i(0)=0. express your answer in terms of e, r, and l. you may or may not need all these variables. use the notation exp(x) for ex.

Answers: 1

Answer

You know the right answer?

Focus question: Does Newton's 1st law of motion apply to the importance of wearing a seat belt? Cho...

Questions