Describe two ways that forces and motion are at work as you make the trip from your house to school.

Explanation:

Motion is just movement needing a force to act upon it. Pushing and pulling are examples of forces that can sped things up or slow things down. All a force ever does is change the motion or speed of the object it is applied to.

Your movement from your house to home is caused by some Forces that is causing to move. As without force there is no motion. These forces can either of push type or pull type.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

as a general rule, scissors have blades less than 6 in (15 cm) long and usually have handles with finger holes of the same size. shears have blades scissors used to cut hair or fabric must be much sharper