how far away should a cliff be form a source of sound to give an echo in 5.3 seconds (given speed of sound at 331m/s

Luke and carrie are driving down a straight section of the interstate at 70 mph in luke's new convertible. carrie is drinking a soda in the passenger seat. when she is done she tosses the bottle straight up in the air, just above the height of the car. what will happen to the bottle if air resistance is neglected? a. the bottle will land in carrie's lap. b. not enough information is given. c. the bottle will land on the interstate in front of the car. d. the bottle will land on the interstate behind the car.

Along wire of diameter 1 mm is submerged in an oil bath of temperature ∞ 31°c. the wire has an electrical resistance per unit length of 0.01 ω/m. if a current of 103 a flows through the wire and the convection coefficient is 500 w/m2·k, what is the steady-state temperature of the wire? from the time the current is applied, how long does it take for the wire to reach a temperature that is within 1°c of the steady-state value? the properties of the wire are 8000 kg/m3, 500 j/kg·k, and 20 w/m·k.

Atension test was conducted on a specimen of aisi 1020 hot-rolled steel having an initialdiameter of 9.11 mm. representative test data are given in table1in the form of force and engineering strain. for strain the extensometer gage length was li= 50.8 mm. in addition, minimumdiameters were measuredmanually with a micrometer in the necked region at several points during the test. after fracture, thebroken halves were reassembled, and the following measurements were made: (1) marks originally 25.4 mm apart and on opposite sides of the necked regionwere 38.6 mm apart due to the lengthwise stretching in the specimen; (2) similar marks originally 50.8 mm apart were 70.9 mmapart; (3) the final minimum diameter in the necked region was 5.28 mma) determine the following material properties: elastic modulus, 0.2% offset yield strength, ultimate tensile strength, percent elongation, and percent reduction in area. b) assume that the test was interrupted upon reaching a strain u = 0.007, and the specimen unloaded to zero force. estimate the elastic strain recovered and the plastic strain remaining. also, what would the new length of the original 50.8 mm gage section. hint: might save time/effort to use excel, mathcad, matlab, etc. to solve part a)table1 data and analysis for a tension test on aisi 1020 hot-rolled steeltest dataforce (p, kn)1. 0.002. 6.673. 13.344. 19.135. 17.796. 17.217. 17.538. 17.449. 17.2110. 20.7711. 24.2512. 25.7113. 25.7514. 25.0415. 23.4916. 21.3517. 18.9018. 17.39engr. strain (ε)1. 02. 0.00053. 0.00104. 0.00155. 0.00236. 0.00317. 0.00508. 0.00709. 0.010010. 0.049011. 0.125012. 0.218013. 0.234014. 0.306015. 0.330016. 0.348017. 0.360018. 03660diameter (d, mm)1. 9.112. 9.113. 9.114. 9.115. 9.116. 9.117. 9.118. 9.119. 9.1110. 8.8911. 8.8912. 8.2613. 8.2614. 7.6215. 6.9916. 6.3517. 5.7218. 5.28