Physics, 10.12.2020 17:50 mackdoolittle1

Task 1: Your Reasons for Making a Will Describe your personal reasons for making a will.

Answers: 3

Show answers

Answers

Answer from: Quest

increase masses, decrease separation

Answer from: Quest

i will answer your question if you answer mine

Answer from: Quest

as we probably am aware that our atmosphere or air have various levels, each level has different gasses, and each gas has another porousness. at the point when the light originates from lower porousness to higher penetrability, it alters its course. with the goal that implies that when the light originates from the moon to the earth, it alters it's course a lot more occasions. it essentially implies that the state of the light piece of the moon is changed on the earth.

not copied too! hope this !

joke:

h o h o hope you have a merry christmas!

Answer from: Quest

force is based upon mass and acceleration.the statement is not always true.

it can be explained from newton's second law of motion.

as per newton's second law of motion the rate of change of momentum is directly proportional to the applied force and takes place along the direction of force.

mathematically it can be written as -

$f\alpha \frac{dp}{dt}$

⇒ $f= k \frac{dp}{dt}$

here k is the proportionality constant whose value is 1.

$f=\frac{dp}{dt}$

$f= \frac{d[mv]}{dt}$

$f= m\frac{dv}{dt} +v\frac{dm}{dt}$

$f=ma+v\frac{dm}{dt}$ [a is the acceleration=dv/dt]

hence we see that force not only depends on mass and acceleration but also on velocity and rate of change of mass. force f will depend on mass and acceleration only when mass is constant.

hence the statement that force is based upon mass and acceleration is false.

Another question on Physics

Physics, 21.06.2019 20:40

In a steady-flow steam power plant system, two adiabatic high-pressure and low-pressure turbines ane used to generate power. superheated steam enters the high-pressure turbine at 8 mpa and 550°c. the steam expands in the high-pressure turbine to a saturated vapor at 3 mpa. in order to increase the powe generation of the power plant, another steam turbine working in a lower pressure ranges is deployed. the outlet vapor from the first turbine is heated up at a boiler to the temperature of 500 c at the constant pressure of first turbine's outlet (3 mpa). then, the vapor enters the second turbine and produces extra work. the exit conditions of the second turbine are 5o kpa and 90 percent quality. if the total power output of the power plant is 25 mw, determine a) the mass flow rate of the water (kg/s). b) heat transfer rate in the boiler (mw). (30 points) 3 mpa 00 c 8 mpa s0 c high pres turbine low pres boiler turbine 50 kpa 3 mpa 09 saturated vapor t heat engine, shown in the figure, operates between high temperature and low temperature of through a heat 4. a carnot tn and tu respectively. this heat engine receives energy from a heat reservoir at t exchanger where the heat transferred is proportional to the temperature difference as ? = k (z,-7, ). it rejects heat at a given low temperature tl. to design the heat engine for maximum work output, find the high temperature, th, as a function of tes and t. (15 points) qe

Answers: 3

Answer

Physics, 22.06.2019 06:00

A1,700kg car is being used to give a 1,400kg car a push start by exerting a force of 140n the impulse on the smaller car during the 30.0s of contact is +670kg*m/s. what is the impulse of the smaller car on the larger car? -814 kg*m/s 0kg *m/s -670kg*m/s -550kg*m/s

Answers: 1

Answer

Physics, 22.06.2019 11:30

Write down two additional questions about earth's magnetic field that will make your presentation more informative.

Answers: 1

Answer

Physics, 22.06.2019 13:00

Avoltaic cell converts chemical energy to

Answers: 1

Answer

You know the right answer?

Task 1: Your Reasons for Making a Will Describe your personal reasons for making a will....