True or false: the total torque on the loop is the same regardless of what is chosen as the position of the vertical axis of rotation.

A1,700kg car is being used to give a 1,400kg car a push start by exerting a force of 140n the impulse on the smaller car during the 30.0s of contact is +670kg*m/s. what is the impulse of the smaller car on the larger car? -814 kg*m/s 0kg *m/s -670kg*m/s -550kg*m/s

You have been hired to design a spring-launched roller coaster thatwill carry two passengers per car. the car goes up a 10-m highhill, then descends 15m to the track's lowest point. you'vedetermined that the spring can be compressed a maximum o 2.0m andthat a loaded car will have a maximum mass of 400kg. for safetyreasons, the spring constant should be 10% larger than the minimumneeded for the car to just make it over the top. a) what spring constant (k) should you specify ? b) what is the maximum speed of a 350 kg car if the spring iscompressed the full amount.

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?