The image shows a pendulum that is released from rest at point A. An illustration of a pendulum at 5 different positions. The central position, the equilibrium position is labeled C. The two positions on the left are labeled A and B respectively. The two positions on the right are labeled D and E respectively. All positions are equally spaced.

Which energy transformation is correct?

From A to C, kinetic energy is transformed into gravitational potential energy.
From C to D, kinetic energy is transformed into gravitational potential energy.
From C to E, gravitational potential energy is transformed into kinetic energy.
From D to E, gravitational potential energy is transformed into kinetic energy.

During the apollo moon missions, astronauts were concerned about the effects of newton's third law of motion when: o a. they ejected waste water, because they were concerned that it would push them off course. o b. they reentered earth's atmosphere, because they were carrying heavy moon rocks. o c. they took off from earth, because a large force was required to generate large acceleration. o d. they detected incoming space debris, because the inertia of the debris could damage their ship.

Atension test was conducted on a specimen of aisi 1020 hot-rolled steel having an initialdiameter of 9.11 mm. representative test data are given in table1in the form of force and engineering strain. for strain the extensometer gage length was li= 50.8 mm. in addition, minimumdiameters were measuredmanually with a micrometer in the necked region at several points during the test. after fracture, thebroken halves were reassembled, and the following measurements were made: (1) marks originally 25.4 mm apart and on opposite sides of the necked regionwere 38.6 mm apart due to the lengthwise stretching in the specimen; (2) similar marks originally 50.8 mm apart were 70.9 mmapart; (3) the final minimum diameter in the necked region was 5.28 mma) determine the following material properties: elastic modulus, 0.2% offset yield strength, ultimate tensile strength, percent elongation, and percent reduction in area. b) assume that the test was interrupted upon reaching a strain u = 0.007, and the specimen unloaded to zero force. estimate the elastic strain recovered and the plastic strain remaining. also, what would the new length of the original 50.8 mm gage section. hint: might save time/effort to use excel, mathcad, matlab, etc. to solve part a)table1 data and analysis for a tension test on aisi 1020 hot-rolled steeltest dataforce (p, kn)1. 0.002. 6.673. 13.344. 19.135. 17.796. 17.217. 17.538. 17.449. 17.2110. 20.7711. 24.2512. 25.7113. 25.7514. 25.0415. 23.4916. 21.3517. 18.9018. 17.39engr. strain (ε)1. 02. 0.00053. 0.00104. 0.00155. 0.00236. 0.00317. 0.00508. 0.00709. 0.010010. 0.049011. 0.125012. 0.218013. 0.234014. 0.306015. 0.330016. 0.348017. 0.360018. 03660diameter (d, mm)1. 9.112. 9.113. 9.114. 9.115. 9.116. 9.117. 9.118. 9.119. 9.1110. 8.8911. 8.8912. 8.2613. 8.2614. 7.6215. 6.9916. 6.3517. 5.7218. 5.28

Will give brainpower answer if answered all correctly!