Physics, 12.08.2020 09:01 sswd

Which of these cannot be a resistor in a series or parallel circuit? A)switch
B) battery
C) light bulb
D) all of these are resistors

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 01:30

Afigure skater is rotating at a rate of 200 revolutions per minute. what is the angular speed, in units of rad/s? 20.9 12000 200 3.33

Answers: 2

Answer

Physics, 22.06.2019 14:10

Your starship, the aimless wanderer, lands on the mysterious planet mongo. as chief scientist-engineer, you make the following measurements: a 2.50-kg stone thrown upward from the ground at 14.0 m/s returns to the ground in 5.70 s ; the circumference of mongo at the equator is 2.20×10^5 km ; and there is no appreciable atmosphere on mongo. (a) the starship commander, captain confusion, asks for the following information: what is the mass of mongo? (b) if the aimless wanderer goes into a circular orbit 2.20×10^4 km above the surface of mongo, how many hours will it take the ship to complete one orbit? (c) an unmanned spacecraft is in a circular orbit around the moon, observing the lunar surface from an altitude of 44.0 km . to the dismay of scientists on earth, an electrical fault causes an on-board thruster to fire, decreasing the speed of the spacecraft by 23.0 m/s . if nothing is done to correct its orbit, with what speed (in km/h) will the spacecraft crash into the lunar surface?

Answers: 1

Answer

Physics, 23.06.2019 06:30

If a 2 ounce coin is dropped from the top of the washington monument and has a final velocity of 300 mph (miles per hour) when it hits the ground, how much kinetic energy will it have at that time?

Answers: 2

Answer

Physics, 23.06.2019 10:10

Now that we have a feel for the state of the circuit in its steady state, let us obtain the expression for the current in the circuit as a function of time. note that we can use the loop rule (going around counterclockwise): e−vr−vl=0. note as well that vr=ir and vl=ldidt. using these equations, we can get, after some rearranging of the variables and making the subsitution x=er−i, dxx=−rldt. integrating both sides of this equation yields x=x0e−rt/l. use this last expression to obtain an expression for i(t). remember that x=er−i and that i0=i(0)=0. express your answer in terms of e, r, and l. you may or may not need all these variables. use the notation exp(x) for ex.

Answers: 1

Answer

You know the right answer?

Which of these cannot be a resistor in a series or parallel circuit? A)switch
B) battery

Questions