A bar on a hinge starts from rest and rotates with an angular acceleration α = 15+4t, where α is in rad/s2 and t is in seconds. Determine the angle in degrees through which the bar turns in the first 2.00 min.

I'm kinda lost ! 1. when marilyn takes her pet dog for a walk, the dog walks at a veryconsistent pace of 0.55 m/s. draw a position-time graph to representmarilyn's dog walking the 19.8 m distance from the front of her house tothe nearest fire hydrant.2. both car a and car bleave school when a stopwatch reads zero. car atravels at a constant 75 km/h, and car b travels at a constant 85 km/h.a) draw a position-time graph showing the motion of both cars. howfar are the two cars from school when the stopwatch reads 2 hrs? calculate the distances and show them on your graph.b) both cars passed a gas station 120 km from the school. when dideach car pass the gas station? calculate the times and show themon your graph.3. the figure below shows the position-time graph showing a shopper'smovement up and down the aisle at a store.a) write a story describing the shopper's movements at the store.b) when does the shopper have a position of 6 m? c) how much time passes between when the shopper enters the aisleand when he gets to a position of 12 m? what is the shopper's averagevelocity between 37 s and 46 s?

Glass is transparent to visibile light under normal conditions; however, at extremely high intensities, glass will absorb most of the light incident upon it. this works through a process known as multiphoton absorption. in this process, several photons are absorbed at the same time. if very intense light whose photons carry 2ev of energy is shined onto a material with a band gap of 4ev, that light can be absorbed through two-photon absorption, because two photons have the right amount of energy to bridge the band gap. what is the minimum number of photons of 800-nm light that are needed to equal or exceed the band gap of fused silica glass

A3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular? a 3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular?