subject
Physics, 04.06.2020 13:17 PinkDivaGirl02

Water at the Antarctica usually exits as ice, making it very difficult to use the water or conduct experiment requiring the water to be in liquid state. A coffee addicted physicist stationed at a research base requires about 0.8 kg of ice for his coffee on the hour. a. How much heat is required to convert 0.8 kg of ice at —35 °C into steam at 100°C? [5] b. Plot the temperature – energy graph for the processes in (a). [5] c. The surface tension of water was determined in a laboratory by using the drop weight method. 100 drops were released from a burette the inner diameter of whose opening is 1.8 mm. The mass of the droplets was 3.78 g. i. Determine the surface tension of the water and, comparing it with the tabulated value, [6] ii. Calculate the relative error of the measurements. [4]

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 00:20
Aparticle of mass m is projected with an initial velocity v0 in a direction making an angle α with the horizontal level ground as shown in the figure. the motion of the particle occurs under a uniform gravitational field g pointing downward. (a) write down the lagrangian of the system by using the cartesian coordinates (x, y). (b) is there any cyclic coordinate(s). if so, interpret it (them) physically. (c) find the euler-lagrange equations. find at least one constant of motion. (d) solve the differential equation in part (c) and obtain x and y coordinates of the projectile as a function of time. (e) construct the hamiltonian of the system, h, and write down the hamilton’s equations (canonical equations) of motion.
Answers: 2
question
Physics, 22.06.2019 01:30
Astone is dropped with no initial velocity from the top of a cliff and hits the ground a time of 3.9 s later. what is the height of the cliff, in units of meters? you may assume that air resistance is negligible. give the answer as a positive number question 15 a figure skater is rotating at a rate of 200 revolutions per minute. what is the angular speed, in units of rad/s? 200 o 20.9 12000 o 3.33
Answers: 2
question
Physics, 22.06.2019 12:00
Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.
Answers: 1
question
Physics, 22.06.2019 13:50
9.98 kg of r-134a at 300 kpa fills a rigid container whose volume is 14 l. determine the temperature and total enthalpy in the container. the container is now heated until the pressure is 600 kpa. determine the temperature and total enthalpy when the heating is completed. use data from the steam tables.
Answers: 1
You know the right answer?
Water at the Antarctica usually exits as ice, making it very difficult to use the water or conduct e...
Questions
question
Mathematics, 04.11.2020 21:40
question
Mathematics, 04.11.2020 21:40
question
Chemistry, 04.11.2020 21:40
Questions on the website: 13722367