Which are ways to improve the design of this experiment? Check all that apply.
Record data onl...
Physics, 05.05.2020 12:45 maytce7237
Which are ways to improve the design of this experiment? Check all that apply.
Record data only at the very end to save time.
Experiment with a wider range of materials.
Use more legible handwriting when recording data.
Use a laboratory galvanometer to make precise measurements.
Test the strength of the electromagnet by varying the number of wire coils.
Answers: 2
Physics, 21.06.2019 22:30
How many molecules are present in 3 mols of silicon dioxide (sio2)?
Answers: 1
Physics, 21.06.2019 23:30
The velocity of car is 80.0 miles per hour. what is the velocity of car in meters per second? (1 km -0.621 miles) m/s
Answers: 2
Physics, 22.06.2019 07:10
1. how much energy is needed to raise the temperature of 40.0 g of argon from 25c to 40c? the specific heat capacity of argon is 0.520 j/(g·k) 2a. 23.0 ml of 0.100 m hcl (standard) are added from a buret to neutralize 50.0 ml of an unknown basic solution. 2b. if the oh- produced in the previous reaction came from ca(oh)2, then what is the molarity of the ca(oh)2? 3.calculate the new freezing-point of a solution when 60.5 grams of cacl2 solute is dissolved in 0.612 kg of water. 4. what is the maximum number of moles of alcl3 that can be produced from 5.0 mol al and 6.0 mol cl2? 5. a sample of oxygen gas has a volume of 150 ml when its pressure is 0.923 atm. if the pressure is increased to 0.987 atm and the temperature remains constant, what will the new volume be? 6. nitrogen gas in a closed container at a temperature of 100.0 oc and 3.0 atm is heated to 300 oc. what is the pressure of the gas at the higher temperature?
Answers: 3
Physics, 22.06.2019 10:50
Asheet of steel 1.5 mm thick has nitrogen atmospheres on both sides at 1200oc and is permitted to achieve a steady-state diffusion condition. the diffusion coefficient for nitrogen in steel at this temperature is 6 x 10- 11 m2 /s, and the diffusion flux is found to be 1.2 x 10-7 kg/m2 -s. also, it is known that the concentration of nitrogen in the steel at the high-pressure surface is 4 kg/m3 . how far into the sheet from this high-pressure side will the concentration be 2.0 kg/m3 ? assume a linear concentration profile.
Answers: 3
Spanish, 02.04.2021 20:20
Mathematics, 02.04.2021 20:20
Mathematics, 02.04.2021 20:20
German, 02.04.2021 20:20
Computers and Technology, 02.04.2021 20:20
Mathematics, 02.04.2021 20:20
History, 02.04.2021 20:20
Social Studies, 02.04.2021 20:20
Biology, 02.04.2021 20:20
Mathematics, 02.04.2021 20:20
Mathematics, 02.04.2021 20:20