Physics, 05.05.2020 05:38 Svetakotok
1. The workpart in a turning operation is 88 min in diameter and 400 mm long. A feed of 0.25 mm/rev is used in this operation. If cutting speed is 3.5 m/s, the too should be changed in every 3 workparts, but if the cutting speed is 2.5 m/sec, the tool can be used to produce 20 pieces between the tool changes. Determine the cutting speed that will allow the tool to be used for 50 parts between tool changes.
Answers: 2
Another question on Physics
Physics, 22.06.2019 10:30
Aparticle moves in the xy plane with constant acceleration. at time zero, the particle is at x = 6 m, y = 8.5 m, and has velocity ~vo = (9 m/s) ˆı + (−2.5 m/s) ˆ . the acceleration is given by ~a = (4.5 m/s 2 ) ˆı + (3 m/s 2 ) ˆ . what is the x component of velocity after 3.5 s? answer in units of m/s.
Answers: 1
Physics, 22.06.2019 12:00
In a set amount of time, a battery supplies 25j of energy to an electric circuit that includes two different loads. one of the loads produces 10 j of heat energy during this time interval. how much heat energy is produced by the second load in this time? explain your answer
Answers: 3
Physics, 22.06.2019 16:40
Acapacitor is storing energy of 3 joules with a voltage of 50 volts across its terminals. a second identical capacitor of the same value is storing energy of 1 joule. what is the voltage across the terminals of the second capacitor?
Answers: 3
Physics, 22.06.2019 18:30
What would people living along the coast in south florida do if there was a hurricane warning? move to locations away from the water flock along coasts to watch the natural phenomenon buy instruments to predict the exact location of the hurricane measure water levels to know the exact time of the hurricane
Answers: 3
You know the right answer?
1. The workpart in a turning operation is 88 min in diameter and 400 mm long. A feed of 0.25 mm/rev...
Questions
Computers and Technology, 13.12.2019 03:31
Mathematics, 13.12.2019 03:31
