How does Mr. Anderson define solubility in the video?

2. What is the solubility of talc in 100 mL of 25 °C water? Explain why talc has this solubility. 3. Describe how increasing temperature affects the solubility of solid and liquid solutes.

4. Why is there less oxygen in ocean water near the equator than in water at higher latitudes? 5. A factory discharges clean, warm water into a nearby stream. Fish keep dying in this part of stream. Explain why.

The desk has a weight of 75 lb and a center of gravity at g. determine the initial acceleration of a desk when the man applies enough force f to overcome the static friction at a and b. also, find the vertical reactions on each of the two legs at a and at b. the coefficients of static and kinetic friction at a and b are ms = 0.5 and mk = 0.2, respectively

Imagine you work as a consultant, and your daily job involves listening to the constructive criticism of others. as part of your job, you must listen to opposing viewpoints to make important decisions. in this activity, you are a consulting dam engineer. you must make a decision about four different dams; should they be repaired, taken down, or left alone? you will listen to contrasting opinions about what should be done with the dams before you make the final decision. as the consulting dam engineer, what do you decide to do with this dam? explain your reasoning. by making your decision, did you support the opinions of the mayor and/or the dam safety official? why or why not? (site 1)

Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?