Physics, 22.04.2020 01:39 jackiemiranda2010

How does the process of grounding occur during a lightning strike?

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 18:00

Air enters a gas turbine with two stages of compression and two stages of expansion at 100 kpa and 17°c. this system uses a regenerator as well as reheating and intercooling – the intercooler returns the air to the inlet temperature. the pressure ratio across each compressor is 4 ; 300 kj/kg of heat are added to the air in each combustion chamber; and the regenerator operates perfectly while increasing the temperature of the cold air by 20°c. determine the system’s thermal efficiency. assume isentropic operations for all compressor and the turbine stages and use constant specific heats at room temperature. (0.378)

Answers: 3

Answer

Physics, 22.06.2019 19:40

Currents in dc transmission lines can be 100 a or higher. some people are concerned that the electromagnetic fields from such lines near their homes could pose health dangers. for a line that has current 150 a and a height of 8.0 m above the ground, what magnetic field does the line produce at ground level? express your answer in teslas and as a percentage of the earth’s magnetic field, which is 0.50 g. is this value cause for worry?

Answers: 1

Answer

Physics, 23.06.2019 01:30

The field lines around one end of a bar magnet are shown below based on the diagram, what can you conclude about the pole of the magnet? a.is a south pole because the field hnes spread out from this end b.a north pole because the field lines spread out from this end c.a nouth pole because the field lines enter the magnet at this end d.is a north pole because the field lines enter the magnet at this end

Answers: 1

Answer

Physics, 23.06.2019 08:30

Industrial processes often require the damping of vibrations. consider a workbench that uses four large ideal springs in place of traditional legs, with each spring supporting one corner of the workbench and exhibiting a force constant of 47500 n/m. this workbench is used when creating products that involve highly unstable chemicals. according to specifications, the acceleration of the manufacturing equipment must be held to less than 22.3 m/s2 for the manufacturing process to proceed safely. the amplitude of vibrations are expected to remain under 0.622 mm throughout. given that the workbench and maufacturing equipment combine to 6.05 kg, find the maximum acceleration expected of the equipment and workbench. (ignore the mass of the springs.)