subject
Physics, 15.04.2020 01:42 georgeonnatreev3400

7. A locomotive is pulling 19 freight cars, each of which is loaded with the same amount of weight. The mass of each freight car (with its load) is 37,000 kg. If the train is accelerating at 0.22m/s2 on a level track, what is the tension in the coupling between the second and third cars

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 00:00
How do the measurements of charge at the different locations on the sphere compare to each other? the charge measurements are different at all locations on the sphere. the charge measurements are virtually not the same at all locations on the sphere except for the charge at the very top and at the very bottom that are equal. the charge measurements are virtually the same at all locations on the sphere except for the charge at the very top. at the top, the conductive sphere has a small disk that is made of different material. the charge measurements are the same at all locations on the sphere. what happens to the charge on the conductive sphere when it is connected to a source of charge such as the electrostatic voltage source? nothing will happen because no charge goes around the surface of the sphere. the charge on the conductive sphere spreads out over the surface of the sphere; being greater in some specific locations on the sphere. the charge on the conductive sphere spreads out uniformly over the surface of the sphere. the charge on the conductive sphere spreads out non-uniformly over the surface of the sphere.
Answers: 3
question
Physics, 22.06.2019 06:30
What is the energy of a photon of ultraviolet radiation with a frequency of 4.4 × 1015 hz? planck’s constant is 6.63 × 10–34
Answers: 3
question
Physics, 22.06.2019 11:30
In order of decreasing light-transmitting capabilities of materials, which is the correct sequence? a. transparent -> translucent -> opaque b. opaque -> transparent -> translucent c. opaque -> translucent -> transparent d. translucent -> transparent -> opaque
Answers: 1
question
Physics, 22.06.2019 21:40
Ahair dryer is basically a duct in which a few layers of electric resistors are placed. a small fan pulls the air in and forces it through the resistors where it is heated. air enters a 1200 w hair dryer at 100 kpa and 22°c and leaves at 47°c. the cross-sectional area of the hair dryer at the exit is 60 cm2. neglecting the power consumed by the fan and the heat losses through the walls of the hair dryer, determine (a) the volume flow rate of air at the inlet and (b) the velocity of the air at the exit.
Answers: 1
You know the right answer?
7. A locomotive is pulling 19 freight cars, each of which is loaded with the same amount of weight....
Questions
question
History, 09.03.2022 14:30
question
Mathematics, 09.03.2022 14:40
Questions on the website: 13722361