1 point
1. Organisms that cannot make their own food and must obtain energy
from the food they eat are called: *
a. Autotrophs
b. Consumers
c. Producers
d. Plants
Help me I’ll give 10 points

Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.

Acommon technique in analysis of scientific data is normalization. the purpose of normalizing data is to eliminate irrelevant constants that can obscure the salient features of the data. the goal of this experiment is to test the hypothesis that the flux of light decreases as the square of the distance from the source. in this case, the absolute value of the voltage measured by the photometer is irrelevant; only the relative value conveys useful information. suppose that in part 2.2.2 of the experiment, students obtain a signal value of 162 mv at a distance of 4 cm and a value of 86 mv at a distance of 5.7 cm. normalize the students' data to the value obtained at 4 cm. (divide the signal value by 162.) then calculate the theoretically expected (normalized) value at 5.7 cm.

Along wire of diameter 1 mm is submerged in an oil bath of temperature ∞ 31°c. the wire has an electrical resistance per unit length of 0.01 ω/m. if a current of 103 a flows through the wire and the convection coefficient is 500 w/m2·k, what is the steady-state temperature of the wire? from the time the current is applied, how long does it take for the wire to reach a temperature that is within 1°c of the steady-state value? the properties of the wire are 8000 kg/m3, 500 j/kg·k, and 20 w/m·k.