Physics, 10.04.2020 04:57 sharnisefrazier

During a testing process, a worker in a factory mounts a bicycle wheel on a stationary stand and applies a tangential resistive force of 135 N to the tire's rim. The mass of the wheel is 1.90 kg and, for the purpose of this problem, assume that all of this mass is concentrated on the outside radius of the wheel. The diameter of the wheel is 60.0 cm. A chain passes over a sprocket that has a diameter of 8.75 cm. In order for the wheel to have an angular acceleration of 3.70 rad/s2, what force, in Newtons, must be applied to the chain?

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 05:00

The earth is constantly spinning on its axis, like you might spin a basketball on your finger. it is this spinning of the earth that causes

Answers: 3

Answer

Physics, 22.06.2019 12:00

Aboat radioed a distress call to a coast guard station. at the time of the call, a vector a from the station to the boat had a magnitude of 45.0 km and was directed 15.0° east of north. a vector from the station to the point where the boat was later found is = 30.0 km, 15.0° north of east. what are the components of the vector from the point where the distress call was made to point where the boat was found? in other words, what are the components of vector c = b - a?

Answers: 3

Answer

Physics, 22.06.2019 16:00

In which of the following is positive work done by a person on a suitcase

Answers: 1

Answer

Physics, 22.06.2019 20:50

An ideal otto cycle has a compression ratio of 8. at the beginning of the compression process, air is at 95 kpa and 27°c, and 750 kj/kg of heat is transferred to air during the constant-volume heat-addition process. assuming constant specific heats at room temperature, determine (a) the pressure and temperature at the end of the heat-addition process, (b) the net work output, (c) the thermal efficiency, and (d) the mean effective pressure for the cycle. (4390 kpa, 1730 k; 423 kj/kg; 56.4%; 534 kpa)

Answers: 1

Answer

You know the right answer?

During a testing process, a worker in a factory mounts a bicycle wheel on a stationary stand and app...

Questions