A constant net force acts on an object. Describe the motion of the object.

A body upon which a constant net force acts means that the body is in a state of constant acceleration.

The constant net force means that the there is no change in the velocity of the object. Hence, the velocity at which the object is moving.

Since the velocity of the body does not change, then the object does not undergo any change in acceleration.

Therefore, the body is in a state of constant acceleration.

Learn more :link

the object is moving with constant acceleration

Explanation:

The motion refers to the change in the position of an object. It is described with respect to distance, displacement, velocity, speed, acceleration, and time. Momentum measures the motion of a body.

Shifting a block is an example of motion.

Force refers to the push or pulls on an object with mass. It results in a change in its velocity.

If a constant net force acts on an object, the object moves with constant acceleration

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

distance = 150m

displ = root (50 ^2 + 100^2)

root(2500+10000)

root 125000