Refrigerant-134a enters a compressor at 180 kPa as a saturated vapor with a flow rate of 0.35 m3/min and leaves at 900 kPa. The power supplied to the refrigerant during the compression process is 2.35 kW. What is the temperature of R-134a at the exit of the compressor

Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?

The space between two 15-in.-long concentric cylinders is filled with glycerin (viscosity = 8.5 × 10-3 lb·s/ft2). the inner cylinder has a radius of 1 in. and the gap width between cylinders is 0.1 in. determine (a) the torque and (b) the power required to rotate the inner cylinder at 180 rev/min. the outer cylinder is fixed. assume the velocity distribution in the gap to be linear.

Ateacher gives students four liquids commonly found in the kitchen - vinegar, apple juice, dish detergent, and milk - and ph indicator strips, which measure acidity. the teacher asks the students to put the liquids in order from most acidic to most basic. what type of investigation could the students conduct to determine the correct order for the liquids?