Physics, 14.03.2020 01:22 NFMZombie

Two pulley wheels of radii 0.2 m and 0.59 m are mounted rigidly on a common axle and clamped together. The combined moment of inertia of the two wheels is 3.4 kg⋅m^2.

A mass 130 kg is attached to a cord wrapped around the smaller wheel and another mass of 69 kg is attached to another cord wrapped around the larger wheel.

Find the angular acceleration of the system. Take clockwise direction as positive. The acceleration of gravity is 9.8 m/s^2.

Answer in units of rad/s^2

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 00:30

Imagine you work as a consultant, and your daily job involves listening to the constructive criticism of others. as part of your job, you must listen to opposing viewpoints to make important decisions. in this activity, you are a consulting dam engineer. you must make a decision about four different dams; should they be repaired, taken down, or left alone? you will listen to contrasting opinions about what should be done with the dams before you make the final decision. as the consulting dam engineer, what do you decide to do with this dam? explain your reasoning. by making your decision, did you support the opinions of the mayor and/or the dam safety official? why or why not? (site 1)

Answers: 1

Answer

Physics, 22.06.2019 03:50

A30 kg weight lies on top of a massless piston of area a = 0.01 m2 the exterior air is at a (constant) p =1 atm and t = 27 c. the interior gas is 0.4 moles of (ideal) n2 and it has initial temperature 27.00 degrees c. 1. what is the initial pressure in the interior? a. 29.4 kpa b. 130.7 kpa c. 101.3 kpa the next three questions concern what happens when an amount of heat q is slowly added to the interior, raising the piston by 1 mm and raising the interior temperature to 27.40 c

Answers: 3

Answer

Physics, 22.06.2019 15:00

Sodium chloride, nacl, is formed when a sodium atom transfers its electron to a chlorine atom. the difference in charge between the two atoms creates a(n) attraction that bonds them together.

Answers: 1

Answer

Physics, 22.06.2019 18:10

Arefrigerator uses r-134a as the working fluid and operates on the ideal vapor-compression refrigeration cycle except for the compression process. the refrigerant enters the evaporator at 120 kpa with a quality of 34 percent and leaves the compressor at 70°c. if the compressor consumes 450 w of power, determine (a) the mass flow rate of the refrigerant, (b) the condenser pressure, and (c) the cop of the refrigerator. (0.00644 kg/s, 800 kpa, 2.03)

Answers: 1

Answer

You know the right answer?

Two pulley wheels of radii 0.2 m and 0.59 m are mounted rigidly on a common axle and clamped togethe...

Questions

Engineering, 27.03.2020 02:07

. The y component of the velocity of a two dimensional, inviscid, incompressible flow is given by v = (4y) ft/s, where y is in ft. Determine the x com...