subject
Physics, 13.03.2020 03:31 maddylucas

A submersible pump is put under the water at the bottom of a well and is used to push water up through a pipe. What minimum output gauge pressure must the pump generate to make the water reach the nozzle at ground level, 51.3 m above the pump?

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 22:30
Heena wants to measure the volume of a ball that is 24 cm across. how should she set up her equation?
Answers: 1
question
Physics, 22.06.2019 19:30
If the area of a square has increased by a factor of 16, by how much has each side increased?
Answers: 3
question
Physics, 23.06.2019 08:00
Athin electrical heater is inserted between a long circular rod and a concentric tube with inner and outer radii of 20 and 40 mm. the rod (a) has a thermal conductivity of ka = 0.15 w/(m*k), while the tube (b) has a thermal conductivity of kb = 0.8 w/(m*k) and its outer surface is subjected to convection with a fluid of temperature t= -15°c and heat transfer coefficient 60 w/(m2 *k). the thermal contact resistance between the cylinder surfaces and the heater is negligible. (a) determine the electrical power per unit length of the cylinders (w/m) that is required to maintain the outer surface of cylinder b at 15°c. (b) what is the temperature at the center of cylinder a?
Answers: 2
question
Physics, 23.06.2019 12:00
What was the approximate temperature of the universe at an age of 1015 s?
Answers: 3
You know the right answer?
A submersible pump is put under the water at the bottom of a well and is used to push water up throu...
Questions
question
Advanced Placement (AP), 23.08.2020 01:01
question
Mathematics, 23.08.2020 01:01
question
Mathematics, 23.08.2020 01:01
Questions on the website: 13722363