The statements below are all true. Some of them represent important reasons why the giant impact hypothesis for the Moon’s formation is taken seriously, and some of them are not relevant to deciding between this and other hypotheses. Sort the statements into the correct bin according to whether or not they provide important support to the giant impact hypothesis. a) models indicate early solar system had mars-size leftover panetesimals. b) moon's composition is similar to earth's mantle. c) moon has a low proportion of easily vaporized ingredients. d) moon lacks active volcanoes. e) moon's distance is gradually increasing. f) moon has synchronous rotation.

the order of importance must be     b e a f c

Explanation:

Modern theories indicate that the moon was formed by the collision of a bad plant with the Earth during its initial cooling period, due to which part of the earth's material was volatilized and as a ring of remains that eventually consolidated in Moon.

Based on the aforementioned, let's analyze the statements in order of importance

b) True. Since the moon is material evaporated from Earth, its compassion is similar

e) True. If the moon is material volatilized from the earth it must train a finite receding speed

a) True. The solar system was full of small bodies in erratic orbits that wander between and with larger bodies

f) False. The moon's rotation and translation are equal has no relation to its formation phase

c) false. The amount of vaporized material on the moon is large

Therefore, the order of importance must be

         b e a f c

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

b.

explanation:

10.0