An experiment is performed in the lab, where the mass and the volume of an object are measured to determine its density. Two completely different valid methods are used. Each experimental method to measure the density is performed, two considerable sets of data are taken on each and the results are compared. The results of the density measurement by each method should be:.
a. dependent on the mass and the volume of the object
b. completely different, because it was measured different ways.
c. correct on the most accurate method and wrong in the other
d. the same within the uncertainty of each measurement method

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Brutus, the dog, is pulling a bone to the left with a force of 20 n. lassie, another dog, is pulling a bone to the right with a force of 18n. what is the net force? a. b. c.

Blood pressure the total amount of blood the heart pumps in one minute 2. cardiac output the number of times your heart beats in a minute 3. dilate the amount of blood that the heart can pump in a single beat 4. heart rate the force exerted on the walls of the blood vessels by the blood that moves through them 5. stroke volume to widen or get larger in size