Physics, 22.01.2020 04:31 megababe04

Why do we use gibbs energy instead of considering the total entropy change when we are determining whether a process will occur?

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 22:40

Ablock of mass m = 2.5 kg is attached to a spring with spring constant k = 710 n/m. it is initially at rest on an inclined plane that is at an angle of θ = 23° with respect to the horizontal, and the coefficient of kinetic friction between the block and the plane is μk = 0.19. in the initial position, where the spring is compressed by a distance of d = 0.16 m, the mass is at its lowest position and the spring is compressed the maximum amount. take the initial gravitational energy of the block as zero. a) what is the block's initial mechanical energy? b) if the spring pushes the block up the incline, what distance, l, in meters will the block travel before coming to rest? the spring remains attached to both the block and the fixed wall throughout its motion.

Answers: 3

Answer

Physics, 22.06.2019 00:00

(science)study the following ocean currents map. an ocean currents map is shown. on the map the locations for san diego, california and savannah, georgia are marked. there is a looping current from the north past san diego and a looping current from the south near savannah which statement is most likely correct about the average temperatures in san diego, california as compared to savannah, georgia? it is higher in savannah because of the cool ocean currents from the south. it is higher in savannah because of the warm ocean currents from the north. it is lower in san diego because of the warm ocean currents from the south. it is lower in san diego because of the cool ocean currents from the north.

Answers: 2

Answer

Physics, 22.06.2019 01:10

Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?

Answers: 3

Answer

Physics, 22.06.2019 15:30

What is the increase in density of a medium due to wave travel?

Answers: 2

Answer

You know the right answer?

Why do we use gibbs energy instead of considering the total entropy change when we are determining w...

Questions