subject
Physics, 20.12.2019 04:31 linaaaaa7

It might be to review any important points in the description of the setup here (see figures 1 and 2). in this experiment, we send light through (1) a collimator slit and collimator lens, (2) a fine diffraction grating, (3) a focusing lens, (4) an aperture disk, and finally (5) a light sensor. the collimators serve to change the original beam shape to a rectangular shape with sharp edges, i. e., collimated. the slit should be set to the smallest size, slit 1 for this experiment. the collimating lens the beam keep its size and shape over the distance it must travel to the light sensor. the diffraction grating diffracts the beam of light. you have seen what happens when light is diffracted in a previous lab. in particular, the light waves spread out and interfere with each other so that if we allow the resulting light to fall on a surface, we see there are locations where there are maxima and minima. what is the equation for determining bright spots from the diffraction grating? experiment with the placement of the focusing lens so that the lamp light is focused on the aperture in front of the light sensor.

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 19:40
Apackage of supplies is dropped from a plane, and one second later a second package is dropped. neglecting air resistance, the relative velocity of the 1st package viewed from the second will 56) a) increase. b) be constant. c) be zero. d) depend upon their weight. e) decrease
Answers: 1
question
Physics, 21.06.2019 22:30
Follow these directions and answer the questions. 1. shine a pencil-thin beam of light on a mirror perpendicular to its surface. (if you don't have a laser light as suggested in the video, you can make a narrow beam from a flashlight by making a cone from black construction paper and taping it over the face of the flashlight.) how does the light reflect? how does the relationship of incident to reflected ray relate to the reflection of water waves moving perpendicular to a barrier? 2. shine a pencil-thin beam of light on a mirror standing on a sheet of paper on the table (or floor) so that you can mark the incident ray and reflected ray. (you can support the mirror from the back by taping it to a wooden block.) 3. mark a line on the paper representing the reflective surface. (the reflective surface of a mirror is usually the back edge.) 4. draw a dashed line perpendicular to the mirror surface at a point where the incident and reflected ray meet. this perpendicular is called a normal to the surface. 5. measure the angles between the rays and the normal. the angle of incidence is the angle formed by the incident ray and the normal to the surface. the angle formed by the reflected ray and normal is called the angle of reflection (r). what is the angle of incidence? what is the angle of reflection? 6. repeat for several different angles. (see report sheet for details.) what appears to be the relationship between the angle of incidence and angle of reflection? in science 1204, what was the relationship for these two angles made by the reflection of waves in a ripple tank? 7. roll a ball bearing so that it hits a fixed, hard surface (a metal plate) at several angles (including head-on). observe the way in which the ball bearing reflects. what generalization can you make about how a ball bearing reflects from a wall? have you proved that light can only behave like a wave?
Answers: 1
question
Physics, 22.06.2019 03:00
According to newtons universal law of gravitation, which would change the parh of the ball so it traces out widest curved path possible?
Answers: 1
question
Physics, 22.06.2019 16:30
Name two kinds of practical electric pumps.
Answers: 2
You know the right answer?
It might be to review any important points in the description of the setup here (see figures 1 and...
Questions
question
Chemistry, 20.09.2019 03:30
Questions on the website: 13722361