Physics, 17.12.2019 03:31 mohamedramadan

The design phase in which a building project's basic functional requirements are first laid out (square footage, utility and equipment needs, and so on) is called the phase.
a. contract
b. documents
c. design/development
d. schematic
e. design programming

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 20:00

When someone slams her books on a table the kinect energy is transferred into vibrations that travel to your ears as sound waves which statement describes the movement of those waves

Answers: 1

Answer

Physics, 21.06.2019 22:00

In a wind tunnel the speed changes as the cross sectional area of the tunnel changes. if the speed in a 6' x 6' square test section is 100 mph, what was the speed upstream of the test section where the tunnel measured 20' x 20'? use conservation of mass and assume incompressible flow. conservation of mass requires that as the flow moves through a path or a duct the product of the density, velocity and cross sectional area must remain constant; i.e., that ova-constant. a model is being tested in a wind tunnel at a speed of 100 mph if the flow in the test section is at sea level standard conditions, what is the pressure at the model's stagnation point? (a) the tunnel speed is being measured by a pitot-static tube connected to a u- tube manometer. what is the reading on that manometer in inches of water? (b) at one point on the model a pressure of 2058 psf is measured. what is the local airspeed at that point?

Answers: 2

Answer

Physics, 22.06.2019 11:30

Two 1.20-m nonconducting wires meet at a right angle. one segment carries + 2.50 µc of charge distributed uniformly along its length, and the other carries - 2.50 µc distributed uniformly along it, as shown in fig. 21.50. ( a. find the magnitude and direction of the electric field these wires produce at point p, which is 60.0 cm from each wire. ( b. if an electron is released at p, what are the magnitude and direction of the net force that these wires exert on it?

Answers: 3

Answer

Physics, 22.06.2019 12:00

You have a resistor and a capacitor of unknown values. first, you charge the capacitor and discharge it through the resistor. by monitoring the capacitor voltage on an oscilloscope, you see that the voltage decays to half its initial value in 2.70 miss . you then use the resistor and capacitor to make a low-pass filter. what is the crossover frequency fc?

Answers: 2

Answer

You know the right answer?

The design phase in which a building project's basic functional requirements are first laid out (squ...

Questions