In a lab experiment, a student is trying to apply the conservation of momentum. two identical balls, each with a mass of 1.0 kg,
roll toward each other and collide. the velocity is measured before and after each collision. the collected data is shown below.
initial velocity
ball a
(m/s)
+1.0
+0.5
+2.0
trial 1
trial 2
trail 3
trial 4
initial velocity
ball b
(m/s)
-2.0
-1.5
+1.0
-10
final velocity
ball a
(m/s)
-2.0
-0.5
+1.0
+1.5
final velocity
ball b
(m/s)
-1.0
-0.5
-2.0
-1.5
+0.5
which trial shows the conservation of momentum in a closed system?
o
o
trial 1
trial 2
trial 3
trial 4
save and exit
next
submit
mark this and return

How do the measurements of charge at the different locations on the sphere compare to each other? the charge measurements are different at all locations on the sphere. the charge measurements are virtually not the same at all locations on the sphere except for the charge at the very top and at the very bottom that are equal. the charge measurements are virtually the same at all locations on the sphere except for the charge at the very top. at the top, the conductive sphere has a small disk that is made of different material. the charge measurements are the same at all locations on the sphere. what happens to the charge on the conductive sphere when it is connected to a source of charge such as the electrostatic voltage source? nothing will happen because no charge goes around the surface of the sphere. the charge on the conductive sphere spreads out over the surface of the sphere; being greater in some specific locations on the sphere. the charge on the conductive sphere spreads out uniformly over the surface of the sphere. the charge on the conductive sphere spreads out non-uniformly over the surface of the sphere.

What do you think car designers do if the damage caused by a crash test is too severe?

Which best describes how fluids change as they travel through different portions of the convection currents? they change to solids at the outer portion of the convection currents. they change to solids at the inner portion of the convection currents. they become more dense at the outer portion of the convection currents. they become more dense at the inner portion of the convection currents