In this experiment you will investigate which of the following properties of faraday's law of electromagnetic induction? (select all that apply.)

1). its dependence on the changing flux of the magnetic field in the region of the coil in which the induced current will flow

2).its dependence on the rate of change of the magnetic field passing through the coil in which the induced current will flow

3).its dependence on the magnitude of the constant magnetic field that gives rise to this effect

4).its dependence on the relative motion of a source of magnetic field and a coil in which the induced currents will flow

if you see a large 60 hz signal being displayed on the oscilloscope while making your measurements, which of the following most likely explains this? (select all that apply.)

1). there is a large magnetic field in the vicinity with a field that is changing at 60 hz.

2).you have a bad connection between the coil and the oscilloscope somewhere.

3).the humidity in the room is causing these spurious signals.

4).the bench top where you are making your measurements is slightly magnetic.

Answered

Explanation:

Part A

According to Faraday's law the induced emf in coil is equal to negative of its rate of change of magnetic flux time the number of turns in the coil.

=

When an emf generated by a change of magnetic flux, produced current of whose magnetic field opposes the change  which produces it.

By the above equation the correct options are 1,2 and 4

Part B

Large signals of  frequency of 60Hz are measured by osciloscope.

Hence the correct option is part 1.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).