subject
Physics, 19.11.2019 05:31 jeffhuffle17

Which statement correctly describes the difference between an atom and a molecule

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 00:00
(science)study the following ocean currents map. an ocean currents map is shown. on the map the locations for san diego, california and savannah, georgia are marked. there is a looping current from the north past san diego and a looping current from the south near savannah which statement is most likely correct about the average temperatures in san diego, california as compared to savannah, georgia? it is higher in savannah because of the cool ocean currents from the south. it is higher in savannah because of the warm ocean currents from the north. it is lower in san diego because of the warm ocean currents from the south. it is lower in san diego because of the cool ocean currents from the north.
Answers: 2
question
Physics, 22.06.2019 01:10
Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?
Answers: 3
question
Physics, 22.06.2019 17:20
In a system with only a single force acting upon a body, what is the relationship between the change in kinetic energy and the work done by the force? answers: work is equal to the change in kinetic energy.work depends on the square of the change in potential energy.work is equal to the negative of the change in kinetic energy.work is equal to the square of the change in kinetic energy
Answers: 2
question
Physics, 22.06.2019 18:00
Asynthetic fiber used in manufacturing carpet has tensile strength that is normally distributed with mean 75.5 psi and standard deviation 3.5 psi. how is the standard deviation of the sample mean changed when the sample size is increased from n equals 8 to n equals 47
Answers: 2
You know the right answer?
Which statement correctly describes the difference between an atom and a molecule...
Questions
question
Health, 01.04.2021 20:00
question
Mathematics, 01.04.2021 20:00
question
English, 01.04.2021 20:00
question
English, 01.04.2021 20:00
Questions on the website: 13722367