You work in a machine design department and need to specify the diameter of a pin that slides back and forth through a hole. the hole diameter is specified as 0.500 inch with a tolerance of ±0.010 inch. the maximum pin diameter must be 0.002 inch smaller than the minimum hole diameter. if the pin diameter has a tolerance of ±0.010 inch, what diameter, in inches, should you specify for the pin?

  distance on the y-axis and time on the x-axis.

explanation:

the instantaneous velocity = change in position/time taken

the slope of the graph should give instantaneous velocity.

  slope of a graph = change in value of y -axis / change in values of x -axis

  comparing both the equations

    change in value of y -axis = change in position

  change in values of x -axis = time taken

so position values should be on the y axis and time values should be on the x axis.

distance on the y-axis and time on the x-axis.