subject
Physics, 04.10.2019 20:00 jerseygirl3467

Your research involves studying o2 concentrations in the mixed layer. upon arriving at your hydrographic station, you observed that the mixed layer is 100 m deep and supersaturated by 5 mmol m-3. the water temperature is 20°c, the salinity is 35 psu, and the saturation water vapor pressure (i. e., humidity ) is 2.3 %. the gas transfer velocity (k+" daz) is cqual to 20 cm hr. (hint: refer to chapter 6 by libes) a. what was the normal atmospheric equilibrium concentration (naec) of o,? b. what is the concentration of oz in the mixed layer? c. calculate the air-sca flux of o2. (hint: make sure all quantities have the same units) d. is oz moving into or out of the water? explain. e. what is one possible reason that could explain why the o; was supersaturated?

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 13:40
How will each of the following changes in demand and/or supply affect equilibrium price and equilibrium quantity in a competitive market; that is, do price and quantity increase or decrease, or are the answers indeterminate because they depend on the magnitudes of the shifts?
Answers: 3
question
Physics, 22.06.2019 21:10
Which radioisotope is used in dating geological formations?
Answers: 3
question
Physics, 23.06.2019 03:10
You have been hired to design a spring-launched roller coaster thatwill carry two passengers per car. the car goes up a 10-m highhill, then descends 15m to the track's lowest point. you'vedetermined that the spring can be compressed a maximum o 2.0m andthat a loaded car will have a maximum mass of 400kg. for safetyreasons, the spring constant should be 10% larger than the minimumneeded for the car to just make it over the top. a) what spring constant (k) should you specify ? b) what is the maximum speed of a 350 kg car if the spring iscompressed the full amount.
Answers: 2
question
Physics, 23.06.2019 13:20
Two wooden members of 80 × 120-mm uniform rectangular cross section are joined by the simple glued scarf splice shown. knowing that β = 22° and that the maximum allowable stresses in the joint are, respectively, 400 kpa in tension (perpendicular to the splice) and 690 kpa in shear (parallel to the splice), determine the largest centric load p that can be applied using mohr's circle. (round the final answer to two decimal places.)
Answers: 1
You know the right answer?
Your research involves studying o2 concentrations in the mixed layer. upon arriving at your hydrogra...
Questions
question
Mathematics, 07.10.2019 17:00
Questions on the website: 13722367