Physics, 23.09.2019 18:20 tylorwsimmons

Now build a model of liquid water. place your materials on a sheet of paper. the regular-size
marshmallows can represent the larger oxygen atoms, and the mini marshmallows can represent the
smaller hydrogen atoms. connect the marshmallows with toothpicks using the picture as a guide. create a
total of four molecules. what was difficult about building the model?

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 00:30

Glass is transparent to visibile light under normal conditions; however, at extremely high intensities, glass will absorb most of the light incident upon it. this works through a process known as multiphoton absorption. in this process, several photons are absorbed at the same time. if very intense light whose photons carry 2ev of energy is shined onto a material with a band gap of 4ev, that light can be absorbed through two-photon absorption, because two photons have the right amount of energy to bridge the band gap. what is the minimum number of photons of 800-nm light that are needed to equal or exceed the band gap of fused silica glass

Answers: 1

Answer

Physics, 22.06.2019 07:30

Boxing gloves are padded to lessen the force of a blow. (a) calculate the force exerted by a boxing glove on an opponent’s face, if the glove and face compress 7.50 cm during a blow in which the 7.00-kg arm and glove are brought to rest from an initial speed of 10.0 m/s. (b) calculate the force exerted by an identical blow in the gory old days when no gloves were used and the knuckles and face would compress only 2.00 cm. (c) discuss the magnitude of the force with glove on. does it seem high enough to cause damage even though it is lower than the force with no glove?

Answers: 1

Answer

Physics, 22.06.2019 12:20

Aball with a mass of 275 g is dropped from rest, hits the floor and rebounds upward. if the ball hits the floor with a speed of 2.40 m/s and rebounds with a speed of 1.70 m/s, determine the following. (a) magnitude of the change in the ball's momentum (let up be in the positive direction.)

Answers: 1

Answer

Physics, 22.06.2019 14:20

4r-134a enters the condenser of a residential heat pump at 800 kpa and 50°c at a rate of 0.022 kg/s and leaves at 750 kpa subcooled by 3°c. the refrigerant enters the compressor at 200 kpa superheated by 4°c determine (a) the isentropic efficiency of the compressor, (b) the rate of heat supplied to the heated room, and (c) the cop of the heat pump. also, determine (d) the cop and rate of heat supplied to the heated room if this heat pump operated on the ideal vapor-compression cycle between the pressure limits of 200 and 800 kpa. (0.757, 4.37 kw, 5.12, 6.18, 3.91 kw)

Answers: 3

Answer

You know the right answer?

Now build a model of liquid water. place your materials on a sheet of paper. the regular-size
...

Questions