subject
Physics, 21.08.2019 18:30 daijahamaker062816

An induced emf of 2.5 v is measured across a coil of 50 closely wound turns while the current through it increases uniformly from 0.0 to 8.0 a in 0.05 s. (a) what is the self-inductance of the coil? (b) with the current at 8.0 a, what is the flux through each turn of the coil? (c) when the current is at 6.0 a, what is the energy stored in the magnetic field of the coil?

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 00:00
During physical science, ms. greene challenged her students to produce an energy transformation. james and jill wrapped a 4-inch nail with a coil of fifty turns of wire. they connected one end of the coil to one terminal of a knife switch. they connected the other terminal of the knife switch to the battery. finally, they connected the end of the coil to the other terminal of the battery. james held the tip of a 1-inch nail near the flat end of the 4-inch nail. jill closed the knife switch quickly and then opened it. the 1-inch nail was pulled toward the 4-inch nail. what is the best explanation of why the nail moved? a) electrical energy was converted to mechanical energy in the 1-inch nail. b) the 4-inch nail became an electromagnet and the magnetic force attracted the 1-inch nail. c) the electric current in the 4-inch nail was converted to mechanical energy in the 1-inch nail. d) the 4-inch nail had a positive charge and the 1-inch nail had a negative charge. opposites attracted.
Answers: 1
question
Physics, 22.06.2019 04:50
Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?
Answers: 1
question
Physics, 22.06.2019 11:30
(2) (a) you have a simple circuit that consists of only a battery (δvbat=1.5v) and two resistors with resistance r1=10ω and r2=5ω, connected in series with each other. what is the current running through the battery? (b) you re-arrange your circuit so now r2 is attached in parallel to r1 rather than in series. what is the current running through the battery? (c) you add an additional resistor r3=7ω on the same branch as r2. what is the current running through the battery? (d) what is the power dissipated in r3?
Answers: 3
question
Physics, 23.06.2019 01:30
Acyclotron is used to produce a beam of high-energy deuterons that then collide with a target to produce radioactive isotopes for a medical procedure. deuterons are nuclei of deuterium, an isotope of hydrogen, consisting of one neutron and one proton, with total mass 3.34×10−27kg. the deuterons exit the cyclotron with a kinetic energy of 6.40 mev .a-what is the speed of the deuterons when they exit? b-if the magnetic field inside the cyclotron is 1.25 t, what is the diameter of the deuterons' largest orbit, just before they exit? c-if the beam current is 350 μa how many deuterons strike the target each second?
Answers: 3
You know the right answer?
An induced emf of 2.5 v is measured across a coil of 50 closely wound turns while the current throug...
Questions
question
Chemistry, 07.07.2021 01:50
question
Mathematics, 07.07.2021 01:50
Questions on the website: 13722367