subject
Physics, 10.08.2019 02:10 janellball16

Practice entering numbers that include a power of 10 by entering the diameter of a hydrogen atom in its ground state, dh=1.06×10−10m, into the answer box.
express the diameter of a ground-state hydrogen atom in meters using a power of 10. do not enter the units; they are provided to the right of the answer box.
dh=

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 14:30
Aray diagram for a refracted light day is shown. what does the dashed line represent
Answers: 2
question
Physics, 21.06.2019 22:00
In a wind tunnel the speed changes as the cross sectional area of the tunnel changes. if the speed in a 6' x 6' square test section is 100 mph, what was the speed upstream of the test section where the tunnel measured 20' x 20'? use conservation of mass and assume incompressible flow. conservation of mass requires that as the flow moves through a path or a duct the product of the density, velocity and cross sectional area must remain constant; i.e., that ova-constant. a model is being tested in a wind tunnel at a speed of 100 mph if the flow in the test section is at sea level standard conditions, what is the pressure at the model's stagnation point? (a) the tunnel speed is being measured by a pitot-static tube connected to a u- tube manometer. what is the reading on that manometer in inches of water? (b) at one point on the model a pressure of 2058 psf is measured. what is the local airspeed at that point?
Answers: 2
question
Physics, 21.06.2019 22:00
•• al and bert are jogging side-by-side on a trail in the woods at a speed of 0.75 m/s. suddenly al sees the end of the trail 35 m ahead and decides to speed up to reach it. he accelerates at a constant rate of 0.50 m/s2, while bert continues on at a constant speed. (a) how long does it take al to reach the end of the trail? (b) once he reaches the end of the trail, he immediately turns around and heads back along the trail with a constant speed of 0.85 m/s. how long does it take him to meet up with bert? (c) how far are they from the end of the trail when they meet?
Answers: 3
question
Physics, 21.06.2019 23:30
Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?
Answers: 3
You know the right answer?
Practice entering numbers that include a power of 10 by entering the diameter of a hydrogen atom in...
Questions
question
History, 05.10.2019 17:30
question
English, 05.10.2019 17:30
question
History, 05.10.2019 17:30
question
Biology, 05.10.2019 17:30
Questions on the website: 13722367