Physics, 17.07.2019 02:10 katherinelondon4002
In experiment 1, when you measured the output with the 51 ohm resistor load in place, you probably still noticed some loading effect. this is because an op amp can only output a certain amount of current before it begins behaving nonlinearly. every op amp has a maximum positive current, called "sourcing maximum negative current, called "sinking current" that can flow into the output terminal of the op amp.) look up the lf412 spec sheet and find nominal value(s) for this sourcing current limit. based on this value, determine the minimum load resistance that could be driven by the lf412 op amp without experiencing any loading effects in experiment 1 3.
Answers: 1
Another question on Physics
Physics, 21.06.2019 18:30
An experiment is designed to test the relationship between the initial height of a basketball before it is dropped to the height of its rebound bounce. the height of the rebound bounce is measured using a scale positioned behind the ball. in the above experiment, which condition would not be controlled? a). the starting height of the ballb). the surface the ball bounces on c). the type of ball d). the method to measure the rebound height of the ball
Answers: 1
Physics, 21.06.2019 18:40
Ten students stand in a circle and are told to make a transverse wave. what best describes the motion of the students? each student bumps the shoulder of his or her neighbor. at the exact time, all students take a step to the right. the students skip clockwise, going in a circular motion. one at a time, each student lifts his or her hands up and then down.
Answers: 1
Physics, 21.06.2019 22:30
Acricket ball of 70g moving with a velocity of 0.5 m/s is stopped by a player in 0.5s what is the force applied to stop the ball
Answers: 1
Physics, 21.06.2019 22:50
As a car drives with its tires rolling freely without any slippage, the type of friction acting between the tires and the road is 100) a) static friction. b) kinetic friction. c) a combination of static and kinetic friction. d) neither static nor kinetic friction, but some other type of friction. e) it is impossible to tell what type of friction acts in this situation.
Answers: 1
You know the right answer?
In experiment 1, when you measured the output with the 51 ohm resistor load in place, you probably s...
Questions
Chemistry, 27.06.2019 10:30
Social Studies, 27.06.2019 10:30
Mathematics, 27.06.2019 10:30
Mathematics, 27.06.2019 10:30
Mathematics, 27.06.2019 10:30
