subject
Physics, 16.07.2019 04:20 melissarodrigue7

The 200-mm test tube also contained some water (besides the metal) that was subsequently added to the calorimeter (in part a. considering a higher specific heat for water, will the temperature change in the calorimeter be higher, lower, or unaffected by this technique error?

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 18:10
Scientists use laser range-finding to measure the distance to the moon with great accuracy. a brief laser pulse is fired at the moon, then the time interval is measured until the "echo" is seen by a telescope. a laser beam spreads out as it travels because it diffracts through a circular exit as it leaves the laser. in order for the reflected light to be bright enough to detect, the laser spot on the moon must be no more than 1.0 km in diameter. staying within this diameter is accomplished by using a special large-diameter laser. part a if λ = 540nm , what is the minimum diameter of the circular opening from which the laser beam emerges? the earth-moon distance is 384,000 km. express your answer to two significant figures and include the appropriate units.
Answers: 1
question
Physics, 22.06.2019 03:30
The focal length of a relaxed human eye is approximately 1.7 cm. when we focus our eyes on a close up object, we can change the refractive power of the eye by about 16 diopters. (a) does the refractive power of our eyes increase or decrease by 16 diopters when we focus closely? explain. (b) calculate the focal length of the eye when we focus closely.
Answers: 3
question
Physics, 22.06.2019 07:30
Some material consisting of a collection of microscopic objects is kept at a high temperature. a photon detector capable of detecting photon energies from infrared through ultraviolet observes photons emitted with energies of 0.3 ev, 0.5 ev, 0.8 ev, 2.0ev, 2.5ev, and 2.8ev. these are the only photon energies observed. (a) draw and label a possible energy-level diagram for one of the microscopic objects, which has four bound states. on the diagram, indicate the transitions corresponding to the emitted photons. explain briefly. (b) would a spring–mass model be a good model for these microscopic objects? why or why not? (c) the material is now cooled down to a very low temperature, and the photon detector stops detecting photon emissions. next, a beam of light with a continuous range of energies from infrared through ultraviolet shines on the material, and the photon detector observes the beam of light after it passes through the material. what photon energies in this beam of light are observed to be significantly reduced in intensity (“dark absorption lines”)? explain briefly.
Answers: 3
question
Physics, 22.06.2019 14:00
This is one type of line graph in which the independent variable is time plotted on the x axis and the dependent variable, also numerical, is plotted on the y axis.
Answers: 2
You know the right answer?
The 200-mm test tube also contained some water (besides the metal) that was subsequently added to th...
Questions
Questions on the website: 13722365