Physics, 10.07.2019 22:10 yay47

Apump is required to pipe water from a well 7.0m in depth to an open-topped water tank at ground level. the pipe at the top of the pump, where the water pours into the water tank, is 2.00cm in diameter. the water flow in the pipe is 5.00m/s.
what is the kinetic energy density of the water flow?
what pressure is required at the bottom of the well? (assume no energy is lost – i. e., that the fluid is traveling smoothly.)
what power is being delivered to the water by the pump? (hint: for the next part, refer to chapter 12)
if the pump has an efficiency of 45%, what is the pump’s electrical power consumption?
if the pump is operating on a 220v power supply (typical for large pieces of equipment like this), how much electrical current does the pump draw?
at 13.5 cents per kilowatt-hour, how much does it cost to operate this pump for a month if it is running 5% of the time?

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 19:00

Prompta snowboarder stands at the top of a hill and decides to see if he can increase his speed on his next trip down the slope.describe one thing the snowboarder could do to incrlase his speed on the slope. explain why this would cause his speed toincrease relate one of newton's laws to this problem.

Answers: 2

Answer

Physics, 22.06.2019 14:20

Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.

Answers: 1

Answer

Physics, 22.06.2019 17:30

Does heating a metal wire increase or decrease its electrical resistance? why?

Answers: 1

Answer

Physics, 22.06.2019 17:40

Which component of the earth’s atmosphere is decreased due to photosynthesis?

Answers: 1

Answer

You know the right answer?

Apump is required to pipe water from a well 7.0m in depth to an open-topped water tank at ground lev...