A13.7 n force is applied to a cord wrapped around a disk of radius 0.43 m. the disk accelerates uniformly from rest to an angular speed of 30.3 rad/s in 3.43 s. determine the angular acceleration of the disk. hint: the average acceleration is the change in angular speed over time.

Water at room temperature of 20.0°c is poured into an aluminum cylinder which has graduation markings etched on the inside. the reading in the graduations is 300.0 cc. the cylinder with the water in it is then immersed in a constant temperature bath at a temperature of 100°c. what is the reading for the level of water on the graduations of the cylinder after the water and the cylinder reach thermal equilibrium with the bath? the volume coefficient of expansion of water is 2.07 x 10^-4 k-1, and the linear coefficient of expansion of aluminum is 23.0 x 10^-6 k-1. a) 305.0 cc b) 304.0 cc c) 303.5 cc d) 303.3 cc e) 304.5 cc

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

Inside of a windmill or a dam is a that is used to transform one type of energy into electrical energy. a. motor b. generator c. transformer d. power pack