An iron ball and an aluminum ball of mass 100 g each are heated to the same temperature and then cooled to a temperature of 20°c. the heat lost by the iron ball is 3.6 kj. the heat lost by the aluminum ball is 7.2 kj. what does this imply?
a) the specific heat of iron is greater.
b) the specific heat of aluminum is greater.
c) the iron ball was heated to a higher temperature.
d) the aluminum ball was heated to a higher temperature.

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Science and technology are interdependent. advances in one lead to advances in the other. give an example of this phenomenon.

There are two routes similar in terrain; however, one route has an incline of approximately 28 degrees, and you must decide on which route to take. what is the maximum road grade that your fully loaded ecv can climb?