Physics, 21.06.2019 19:30 BrodsterBj

Describe the path of a ray that approaches a mirror parallel to the principal axis.

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 11:30

With the simplified model of the eye, what corrective lens (specified by focal length as measured in air) would be needed to enable a person underwater to focus an infinitely distant object? (be careful-the focal length of a lens underwater is not the same as in air! assume that the corrective lens has a refractive index of 1.62 and that the lens is used in eyeglasses, not goggles, so there is water on both sides of the lens. assume that the eyeglasses are 1.90

Answers: 1

Answer

Physics, 23.06.2019 02:40

An air standard cycle with variable specific heats is executed in a closed system and is composed of the following four processes. 1-2 isentropic compression 100 kpa and 22°c to 600 kpa 2-3 v=constant heat addition to 1500 k 3-4 isentropic expansion to 100 kpa 4-1 p=constant heat rejection to initial state (a) show the cycle on p-v and t-s s (b) calculate the net work output per unit mass (409 kj/kg) (c) determine the thermal efficiency (47.9%)

Answers: 1

Answer

Physics, 23.06.2019 02:50

Adielectric-filled parallel-plate capacitor has plate area a = 30.0 cm2 , plate separation d = 9.00 mm and dielectric constant k = 3.00. the capacitor is connected to a battery that creates a constant voltage v = 15.0 v . throughout the problem, use ϵ0 = 8.85x10-12 c2/n.m2 . find the energy u1 of the dielectric-filled capacitor.

Answers: 2

Answer

Physics, 23.06.2019 07:00

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?

Answers: 3

Answer

You know the right answer?

Describe the path of a ray that approaches a mirror parallel to the principal axis....

Questions