Ineed ! a 2.0 kilogram toy cannon is at rest on a frictionless surface. a. remote triggering device causes a 0.005 kilogram projectile to be fired from the cannon. which of the following equations best describes this system after the cannon is fired? a) speed of cannon + speed of projectile=0b) mass of cannon + mass of projectile = 0 c) velocity of cannon + velocity of projectile=0d)momentum of cannon + momentum of projectile= 0 d is the correct answer but i need an explanation of why it is the right answer

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)

Four objects each with charge +2.0×10−7c are located at the corners of a square whose sides are 2.0 m long. part a what quantities can be determined using this information? check all that apply. the electric force on a charged object placed at the center of the square. the mass of each object. the total electric potential energy of the system consisting of the four charged objects. part b find the electric force on a charged object placed at the center of the square.

Awelder using a tank of volume 7.50×10^-2 m^3 fills it with oxygen (with a molar mass of 32.0 g/mol ) at a gauge pressure of 3.30×10^5 pa and temperature of 37.1 ∘c. the tank has a small leak, and in time some of the oxygen leaks out. on a day when the temperature is 23.1 ∘c, the gauge pressure of the oxygen in the tank is 2.00×10^5 pa . a) find the initial mass of oxygen. b) find the mass of oxygen that has leaked out.