Like the charged rubber balloon described at the end of section 1.14, a charged soap bubble experiences an outward electrical force on every bit of its surface. given the total charge q on a bubble of radius r, what is the magnitude of the resultant force tending to pull any hemispherical half of the bubble away from the other half? (should this force divided by 2πr exceed the surface tension of the soap film, interesting behavior might be expected! )

Two identical 82 mg dust particles very far apart (pee 0) are moving directly toward each other at a speed of 3698 m/s. the charge on each is-719 ? c. determine how close they will get to each other. let k = 9x109 n-m2/c2 & ignore gravity.

Because air contracts as it cools, the air pressure inside a freezer is typically lower than on the outside. why do ice cubes inside a freezer tend to shrink over time? a. the ice dissolves oxygen from the air, forming a denser crystalline matrix.b. the ice reacts chemically with carbon dioxide in the air, forming gaseous carbon compounds.c. the ice melts, and then the liquid freezes as ice crystals on the bottom of the freezer.d. the ice sublimes, and then the water vapor deposits as ice crystals on the sides of the freezer.

Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.