I"m getting the different expressions confused while I'm doing Ratio Proportion -Converting Between Systems. Here is a couple of example.. qt ii = L
gr ¾ = mg

The data in the table represent the height of an object over time. which model best represents the data? height of an object time (seconds) height (feet) 05 1 50 2 70 3 48 quadratic, because the height of the object increases or decreases with a multiplicative rate of change quadratic, because the height increases and then decreases exponential, because the height of the object increases or decreases with a multiplicative rate of change exponential, because the height increases and then decreases

You drop a rubber ball off the roof of a 50 meter high building onto a paved parking lot. it bounces back up with every bounce, but not quite all the way back up to you. after the first bounce it bounces back only 80 percent of the distance it was dropped from. the pattern continues, meaning after every bounce it comes up to just 80 percent of the previous maximum height. so if before the first bounce the height is 50 meters, what height does the ball reach after the fifth bounce? round your answer to one decimal place and chose the correct response from the choices below:

Write the following as a base and exponent