Keeping water supplies clean requires regular measurement of levels of pollutants. The measurements are indirect- a typical analysis involves forming a dye by a chemical reaction with the dissolved pollutant, then passing light through the solution and measuring its " absorbence." To calibrate such measurements, the laboratory measures known standard solutions and uses regression to relate absorbence and pollutant concentration. This is usually done every day. Here is one series of data on the absorbence for different levels of nitrates. Nitrates are measured in centigrams per liter of water.

Nitrates 10 7 15 30 20 60 60 100 140 320
Absorbance 5 7 10 25 40 90 130 190 230 220
Chemical theory says that these data should lie on a straight line. If the correlation is not at least 0.997, something went wrong and the calibration procedure is repeated.

(a) Find the correlation r.
r =

(b) Must the calibration be done again? (Answer YES or NO).

it is probably the graph on the bottom right.

hello from mrbilldoesmath!

answer:

the domain is the set { -2, 0, 2, 3}

discussion:

the domain is the set of x values in the ordered pairs (x,y). taking the x, or first component, of each ordered pair gives   -2, 0, 2, 3.

you,

mrb

5x + 5

step-by-step explanation:

you should always add the diagrams and graphs we cannot see. this particular question is kind of borderline because we can make a graph for you.

(f + g)x = -x^2 +3x + 5 + x^2 + 2x

(f + g)x = 5x + 5

the graph of z = 5x + 5 is shown below. always use desmos when in doubt.

option: d is the correct answer.

d) none of the above.

step-by-step explanation:

clearly from the figure attached to the question we could see that there is no shape given. hence without any shape given in the figure and after rotation we can't obtained a square pyramid.

since, to obtain a image we need a proper figure of the pre-image so that it can be transformed.

hence, the correct answer is:

d) none of the above.

step-by-step explanation: