Engineering, 16.03.2022 01:00 izabellehannah7165
Calculate the coefficient of friction during contact at tool-workpiece interface for a material where the shear stress is 400 MPa and the normal contact stress is 600 MPa.
Answers: 3
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
Engineering, 04.07.2019 19:10
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
Engineering, 04.07.2019 19:20
Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.
Answers: 3
Calculate the coefficient of friction during contact at tool-workpiece interface for a material wher...
Mathematics, 17.12.2020 21:40
Mathematics, 17.12.2020 21:40
Mathematics, 17.12.2020 21:40
Mathematics, 17.12.2020 21:40
Chemistry, 17.12.2020 21:40
Mathematics, 17.12.2020 21:40
Mathematics, 17.12.2020 21:40
Health, 17.12.2020 21:40
Mathematics, 17.12.2020 21:40
Mathematics, 17.12.2020 21:40