Engineering, 06.02.2022 21:10 kenken2583

Based on the following passage, what foundation construction worker likely makes the most money and why? For pile driver operators, inspecting and maintaining heavy equipment properly and safely is a large part of the job. Knowing and following safety codes on a construction site is paramount in this position, as is a commercial driver’s license. Geotechnical engineers conduct site investigations to determine what kind of stabilizing the soil may need or what kind of foundation is most appropriate for a proposed structure. They assess the risk of earthquakes, landslides, and soil liquefaction on a site and then plan earthwork accordingly.

A) geotechnical engineers because they work remotely
B) pile driver operators because they are required to be licensed
C) geotechnical engineers because their job requires scientific education
D) pile driver operators because their job is more dangerous

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 06.07.2019 03:20

Steam at a pressure of 100 kpa and a quality of 50% initially fills a rigid vessel having a volume of 0.5 m^3. the steam is then heated, causing the pressure in the vessel to rise to 150 kpa. determine: i. the mass of the steam in the vessel. ii. the temperature and quality of the steam after the heating process. ii the mass of the vapour, mg and liquid, m in the vessel after the heating process. if the steam in the vessel is now further heated, what would the pressure and temperature in the vessel be when all steam has turned into saturated vapour? b. sketch the processes in part (a) and part (b) on p-v and t-v diagrams, indicating clearly the temperatures, pressures and the paths. c. (0.59kg, 111.4°c, 73%, 0.4307kg, 0.1 593kg, 2.11 bar, 121.84°c)

Answers: 1

Answer

Engineering, 06.07.2019 04:10

Aspherical thermocouple measurement errors a spherical thermocouple made of constantin transfer coefficient between the gas and the thermocouple is h used to measure the temperature of a gas. the heat 400 w/m2 k. calculate the maximum diameter d of the thermocouple if the thermocouple's measurement error should be w 23 within 5% of the initial temperature difference in 5 seconds. for constantin, k 8920 kg/m3, and c 410 j/kg. k.

Answers: 3

Answer

You know the right answer?

Based on the following passage, what foundation construction worker likely makes the most money and...

Questions