QUESTION:
Which scenario illustrates a tolerance stack in the part design?
POSSIBLE ANSWERS:...
Engineering, 23.12.2021 14:00 ronaldo22
QUESTION:
Which scenario illustrates a tolerance stack in the part design?
POSSIBLE ANSWERS:
Operator inexperience with maintaining tool offsets allows the machining to vary widely from
the specifications set forth in a part blueprint, resulting in an unusable part.
Due to a damaged tool, the cutting of a metal part did not meet the tolerance specification set
forth in a blueprint, resulting in a scrapped part.
By chance, the machining of a part met the tolerance specifications set forth in a blueprint, but
a
the accumulation of variation from the upper or lower limits of the tolerance results in an unusable
part.
Answers: 3
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Engineering, 04.07.2019 18:10
Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when
Answers: 1
Health, 04.12.2020 17:10
Mathematics, 04.12.2020 17:10
Biology, 04.12.2020 17:10
Mathematics, 04.12.2020 17:10
Mathematics, 04.12.2020 17:10
Mathematics, 04.12.2020 17:10