Engineering, 12.12.2021 04:40 PerfectMagZ
Why do we need to perform mensuration and calculation in mechanical drafting?
Answers: 2
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Why do we need to perform mensuration and calculation in mechanical drafting?...
Mathematics, 27.01.2021 05:50
Mathematics, 27.01.2021 05:50
Mathematics, 27.01.2021 05:50
Mathematics, 27.01.2021 05:50
English, 27.01.2021 05:50
Mathematics, 27.01.2021 05:50
Advanced Placement (AP), 27.01.2021 05:50
Biology, 27.01.2021 05:50