Engineering, 10.12.2021 23:00 lsrgb

Assume the following LTI system where the input signal is an impulse train (i. e. , x(t) = ∑ (t − nT0) [infinity] n=−[infinity] . a) Find the Fourier series coefficient of x(t). Then find its Fourier transform and sketch the magnitude and phase spectra.
b) Sketch the magnitude and phase spectra of the output (i. e., |Y()|and ∡Y()) if the system is a low-pass filter with H() = { 1 || < 30 2 0 otherise , where 0 = 2π T0 .
c) Sketch the magnitude and phase spectra of the output if the system is a high-pass filter with H() = { 1 || > 50 2 0 otherise , where 0 = 2π T0 .
d) Sketch the magnitude and phase spectra of the output if the system is a filter with H() = 1 1+j.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.

Answers: 3

Answer

You know the right answer?

Assume the following LTI system where the input signal is an impulse train (i. e. , x(t) = ∑ (t − nT...

Questions