Engineering, 10.12.2021 18:30 Riley3833

25. Ratchets and Screwdrivers are the same tool. True or False
26. A battery tester can be used to jump start a vehicle.
True or False
27. An adjustable wrench is good to have as it can be changed to fit any nut size. True or False
28. A Mechanic stethoscope is specially designed so that the noises produced by a problem in the vehicle can be identified.
True or False
29. A Compression Tester test the performance of the engine valves and piston rings. True or False
30. A battery pack is a good tool to have when travelling.
True or False
31. Using the correct size hand tool makes it easier to tighten or loosen nuts, bolts and screws.
True or False
32. A computer scanner can tell you every problem in a vehicle.
True or False
33. A Breaker Bar gives the same torque as regular length wrenches. True or False
34. A Pilot Bearing Puller can also be used to pull out a Crankshaft. True or False
25. Ratchets and Screwdrivers are the same tool.
True or False
26. A battery tester can be used to jump start a vehicle.
True or False
27. An adjustable wrench is good to have as it can be changed to fit any nut size. True or False
28. A Mechanic stethoscope is specially designed so that the noises produced by a problem in the vehicle can be identified.
True or False
29. A Compression Tester test the performance of the engine valves and piston rings. True or False
30. A battery pack is a good tool to have when travelling.
True or False
31. Using the correct size hand tool makes it easier to tighten or loosen nuts, bolts and screws.
True or False
32. A computer scanner can tell you every problem in a vehicle.
True or False
33. A Breaker Bar gives the same torque as regular length wrenches. True or False
34. A Pilot Bearing Puller can also be used to pull out a Crankshaft. True or False

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 12:10

On a average work day more than work place firs are reorted

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

You know the right answer?

25. Ratchets and Screwdrivers are the same tool. True or False
26. A battery tester can be...

Questions