subject
Engineering, 25.11.2021 08:20 DESTROYERMODE2308

The steady-state process gain for the actuator, main process and sensor, considered as a single process, is 5.0 gpm/mA. (a.5 pts.) Consider a P-only controller to be switched on and the proportional gain is 0.3 mA/gpm. What is the magnitude of the control signal sent to the actuator at 10 seconds

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
question
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
You know the right answer?
The steady-state process gain for the actuator, main process and sensor, considered as a single proc...
Questions
question
Social Studies, 11.03.2020 07:16
question
Mathematics, 11.03.2020 07:17
question
Chemistry, 11.03.2020 07:19
question
Social Studies, 11.03.2020 07:20
Questions on the website: 13722363